Releasing the rear left and right shock absorber from the body

NOTE: Perform the steps on the right and left side.

Releasing the rear shock absorber from the body

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Release all the cables from holder (2) .
Unlock plug connection (1) and disconnect.

Courtesy of BMW OF NORTH AMERICA, INC.
WARNING:
Car may slip off the vehicle hoist where components are supported.
Danger! Immobilization period-threatening injuries!
- Secure the vehicle hoist against lowering and lifting.
- Make sure that the vehicle does not lift off the mounting plates on the vehicle lift.
Courtesy of BMW OF NORTH AMERICA, INC.
Position special tool 2 219 012with special tools 2 411 683and 2 305 379under wheel carrier (1) .
Support wheel carrier (1) using special tool 2 219 012 .
Do not press against the spring force of the coil spring.
Loosen screws (1) .
Disconnect the special tool 2 219 012 and set it aside.

Courtesy of BMW OF NORTH AMERICA, INC.