Installing the removed EME

NOTE: RISK OF DAMAGE
Pressure on the lid or busbars results in destruction of the components in the electrical machine electronics.

Do not exert any pressure on the lid of the electrical machine electronics.
Do not exert any pressure on the busbars of the electrical machine electronics.
Do not place any tools or objects on the lid of the electrical machine electronics.

Courtesy of BMW OF NORTH AMERICA, INC.

Do not place it on lid (1) .
Repair information relating to high-voltage components
Remove the lid of the special tool 5 A2D AC5.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the special tool 5 A2D AFO on EME (2) as
shown and secure it using knurled screw (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Position the special tool 5 A2D AF2 on EME (2) as
shown and secure it using knurled screw (1) .

Courtesy of BMW OF NORTH AMERICA, INC.
Raise EME (1) out of special tool 5 A2D AC5.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove and dispose of seals (1) and (2) .

Clean the sealing surfaces (1) and (2) with the brake cleaner.

CONSUMABLE SPECIFICATION

Brake cleaner 2.0	500 ml, Spray can	83192365214
	20, Canister	83192365215

Courtesy of BMW OF NORTH AMERICA, INC.

Dry sealing surfaces (1) and (2) with a clean, lint-free cleaning cloth.
Replace the seals (1) .
Parts: Seal
Replace gasket (2) .
Parts: Seal
Position the electrical machine electronics (EME) (1) in the electrical machine.
Remove special tools 5 A2D AF2 and 5 A2D AF0.

Courtesy of BMW OF NORTH AMERICA, INC.
Do not touch conductor lines!

Tighten screws (arrows).

TIGHTENING TORQUE SPECIFICATION

Electrical machine electronics to housing
M6 Replace screw.	Tightening torque	8 Nm 90°

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (5) .

TIGHTENING TORQUE SPECIFICATION

EME busbar at high-voltage connection
M5 Replace screw.	Tightening torque	4.5 Nm

Tighten nuts (4) .

TIGHTENING TORQUE SPECIFICATION

Excitation cable to electrical machine electronics
M5	Tightening torque	3.9 Nm

Tighten the screws (2) .

TIGHTENING TORQUE SPECIFICATION

Electrical machine electronics busbar to aggregate connection
M5 Replace screw.	Tightening torque	4.5 Nm

Install wiring harness mounting (3) .
Close the plug connection (1) .
Connect connectors (2) and lock.
Close the retainer (1) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the sound insulation on the left
Install the sound insulation (2) .
Secure clamps (1).

Courtesy of BMW OF NORTH AMERICA, INC.