Installing the high-pressure line between the high-pressure pump and the high-pressure rail
- Guide the special tool 2 413 106
out and remove.
- Thread in and install the high pressure line (2).
- Tighten union nut (1) hand tight.
- Tighten union nut (1).TIGHTENING TORQUE SPECIFICATION
High pressure line between high pressure pump and rail M14 Tightening torque 33 Nm
Follow-up work
- Refer to INSTALLING ALL IGNITION COILS .
- Refer to WHEN WORKING ON THE LAST CYLINDER: MOUNTING THE SERVICE OPENING IN THE SOUND INSULATION ON TOP OF THE ENGINE .
- Refer to INSTALLING THE CYLINDER HEAD COVER ACOUSTIC COVER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to INSTALLING ACOUSTIC COVER .