Replacing rear timing case cover
Replacement: Remount crankshaft sensor
- For timing case cover replacements:
Remount crankshaft sensor.
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
- Loosen the screw (1) and remount the crankshaft sensor (2) .
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Crankshaft sensor to timing case cover | ||
| Tightening Torque | 4.6 Nm | |
NOTE:
RISK OF DAMAGE
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
- Do not use any metal-cutting tools.
- Remove the seal residue in areas (1)
using special tool 0 495 102 (11 4 470)
.
- Check the fitting sleeves (1) for damage and replace as needed.
- Check for correct fit of fitting sleeves (1) .
NOTE:
TECHNICAL INFORMATION
For additional information see: OVERVIEW OF CONSUMABLES (APPLICABLE BMW PARTS CATALOGUE) .
For additional information see: OVERVIEW OF CONSUMABLES (APPLICABLE BMW PARTS CATALOGUE) .
NOTE:
TECHNICAL INFORMATION
The processing time of the liquid sealing compound can be at a maximum of 10 min.
Commissioning of the assembly is not possible until 25 minutes after the processing time.
Non-observance can lead to leaks in the assembly.
The processing time of the liquid sealing compound can be at a maximum of 10 min.
Commissioning of the assembly is not possible until 25 minutes after the processing time.
Non-observance can lead to leaks in the assembly.
- Apply the sealing compound in area (1) along the inner edge.
SEALING COMPOUND SPECIFICATION
| Loctite 5970 liquid sealing compound Processing time <10 minutes at room temperature | 50 ml, Cartridge | 83190404517 |
TECHNICAL DATA SPECIFICATION
| Height of the sealing bead | |
| Tightening Torque | 2.0 mm... 2.5 mm |
- Mount special tool 0 496 137 (11 8 815) and 0 496 132 (11 8 810) on the crankshaft.
- Replace screws (1)
to (11)
.
Parts: Screws
- Carefully mount the new timing case cover (A) .
- Tighten screws in the sequence (1) to (11) .
TIGHTENING TORQUE SPECIFICATION
| Rear timing case cover on crankcase | ||
| M6 x 31 Replace screws. |
Joining torque | 8 Nm |
| Angle of rotation | 90° | |
- Connect and lock the connector (1) .
- Make sure the connector (1) engages audibly.