When replacing the door trim panel: Replace parapet

• Replace the parapet (2).

  Parts:  Parapet.

• Shorten the welding pin (1) at the new parapet (2) by the dimension (a).
  TECHNICAL DATA SPECIFICATION
  
  

  Shorten the welding pin
  Dimension a	3 mm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Saw off each welding pin (1) on the new parapet along the molding (2).
• Check that the welding pins (1) do not extend beyond the door trim panel.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the moldings (1) with a suitable tool.

NOTE: Use a scalpel.

Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and correctly position the parapet (1) in the door trim panel.
• Clip the parapet (1) into the detents (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the parapet using repair screws (1).
• Tighten the repair screws.
  TIGHTENING TORQUE SPECIFICATION
  
  

  Shoulder to door trim panel
  Screw	Tightening torque	2 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  CONSUMABLE SPECIFICATION
  
  

  Repair screw  Delta PT4

  ø4 mm, l = 12 mm,

  07149200941

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the welding pin (1) with lock washers (2).
  CONSUMABLE SPECIFICATION
  
  

  Lock washer

  Outside diameter: 20.5 mm, Shaft diameter: 6 mm,

  07147295776

  Courtesy of BMW OF NORTH AMERICA, INC.

  Courtesy of BMW OF NORTH AMERICA, INC.