Installing the rear wheel arch trim
NOTE:
TECHNICAL INFORMATION
To ensure optimal bonding, the bonding surfaces on the inner side of the wheel arch trim panels must not be painted!
You must apply the adhesive pad (two-sided adhesive tape) to the wheel arch trim panel before painting the wheel arch trim panel.
To ensure optimal bonding, the bonding surfaces on the inner side of the wheel arch trim panels must not be painted!
You must apply the adhesive pad (two-sided adhesive tape) to the wheel arch trim panel before painting the wheel arch trim panel.
- Remove the adhesive residues on the bonding surfaces (1) and (2).
- Clean bonding surfaces (1) and (2) with cleaning agent R2.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Adhere to the air drying time of 2 min.
- Detach protective films from adhesive pads (doublesided adhesive tape).
- Position the wheel arch trim (1) and (2) according to the specified dimensions and press down tightly.
Dimension a = about 1.0 mm.
Dimension b = about 3.0 mm.