Install support for bumper cover at front bottom
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Thread in the support for the bumper cover at front bottom (2) and position.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Front bottom bumper cover support to deformation element Combination ovalhead machine screw Tightening torque 10 Nm
Follow-up work
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to IF INSTALLED: INSTALLING THE FRONT RADAR SENSOR (FRS) WITH THE BRACKET .
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to REPLACING UPPER ADAPTER FOR BUMPER TRIM PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .