Installing the tandem brake master cylinder (vehicles with automatic transmission)
- Insert the tandem brake master cylinder (1) into the brake booster.
- Replace nuts (2).
Parts: Nuts
- Place and tighten nuts (2).
TIGHTENING TORQUE SPECIFICATION
| Tandem brake master cylinder in the brake booster | ||
| Replace nuts. M8 |
Tightening torque | 23 Nm |
- Fit brake lines (1) and tighten.
TIGHTENING TORQUE SPECIFICATION
| Brake pipe screw connection/Union screws | ||
| tightening torque | 17 Nm | |
Follow-up work
- Refer to INSTALLING THE EXPANSION TANK (VEHICLES WITH AUTOMATIC TRANSMISSION) .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to IF INSTALLED: REMOVING STRUT BRACE IN THE REAR OF THE ENGINE COMPARTMENT .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .