Removing the convertible top wiring harness
Preliminary work
- Refer to REMOVING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to REMOVING THE LOADING EDGE TRIM .
- Refer to REMOVING THE UPPER LUGGAGE COMPARTMENT TRIM PANELS .
- Refer to REMOVING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
- Refer to REMOVING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
- Refer to REMOVING THE WINDOW CHANNEL STRIP AT REAR OUTER LEFT AND RIGHT .
- Refer to REMOVING REAR SEAT BENCH .
- Refer to REMOVING LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to REMOVING REAR SEAT BACKREST .
- Refer to REMOVING THE HEAD RESTRAINT ON REAR LEFT AND RIGHT .
- Refer to REMOVING THE REAR LEFT AND RIGHT HEAD RESTRAINT GUIDES .
- Refer to REMOVING THE TRIM PANEL AT THE TOP OF THE ROLLOVER PROTECTION SYSTEM .
- Refer to REMOVING THE UPPER CROSS MEMBER COVER .
- Refer to REMOVING THE INNER DOOR SILL COVER STRIP ON THE LEFT AND RIGHT .
- Refer to REMOVING SIDE TRIM PANEL, REAR LEFT AND RIGHT .
- Refer to REMOVING THE INNER REAR LEFT AND RIGHT WINDOW CAVITY FINISHER STRIP .
- Refer to REMOVING THE SUPPORT FOR THE REAR INNER WINDOW RECESS FINISHER COVER ON THE LEFT AND RIGHT .
- Refer to REMOVING THE CONVERTIBLE TOP COMPARTMENT LID .
- Refer to REMOVING THE CONVERTIBLE TOP COMPARTMENT .
- Refer to REMOVING COMPLETE SOFT TOP .
- Refer to REMOVING CONVERTIBLE TOP BOW, FRONT .
Convertible top wiring harness
- Unlock plug connection (1) and disconnect.
- Unclip wiring harness (2)
on the holders.
- Slightly open the convertible top to enable accessibility.
- Release the convertible top wiring harness (1) at the Velcro holders (2) and feed it out.
- Release the screws in area (3) from the rear.
- Lightly raise the holder (4)
and feed out the convertible top wiring harness (5)
.
- Unlock plug connections (1) and disconnect.
- Feed out the convertible top wiring harness (2) from the cloth flaps (3) .
- Release the expanding rivet (1) .
- Remove the Hall effect sensors (2) .
- Unclip the convertible top wiring harness (3)
at the existing holders and feed it out.
- Release the cable tie (1) and remove the convertible top wiring harness (2) .