Installing the headlining side rear

Position the headlining (2).
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATION

Headlining support to hood linkage
Torx bolt	Tightening torque	2.8 Nm

G15339833

Courtesy of BMW OF NORTH AMERICA, INC.

Position the headlining (2).
Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATION

Headlining support to hood linkage
Torx bolt	Tightening torque	2.8 Nm

G15339832

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in the tension cable (1) at the retaining tab (2) on the convertible top brace.

G15339831

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in the tension cable (1) at the retaining strap (2) and at the convertible top linkage in the area (3) in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Continue feeding in the tension cable (1) at the convertible top linkage in the area (2) in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Route the tension cable (1) through the guides (2) and (3) at the convertible top linkage.

Courtesy of BMW OF NORTH AMERICA, INC.
Continue routing the tension cable (1) around the guide (2) in arrow direction.
Fasten the tension cable (1) on the convertible top linkage using a new Jetpress plastic rivet (3).

G15339840

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in the tension cables (1) through the guides at the convertible top linkage (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Position the rubber grommet (2) at the tension cables (1).
Feed in the tension cables (1) at the guide (3) on the convertible top linkage.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the rubber grommet (3) at the tension cables (4).
Fasten the tension cables (4) on the convertible top linkage using the bolt (2).
Insert the retaining clip (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Position the tension cable (2).
Fasten blind rivet (1).

G15339828

Courtesy of BMW OF NORTH AMERICA, INC.