Installing the end cap of the slide/tilt sunroof frame
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Position the end cap (2) .
- Fasten blind rivet (1) .
Follow-up work
- Refer to INSTALLING THE DRIVETRAIN FOR THE GLASS SLIDE/TILT ROOF PANEL .
- Refer to COMPLETELY INSTALLING THE SLIDING/TILTING SUNROOF .
- Refer to INSTALLING THE HEADLINING (WITH SLIDING/TILTING SUNROOF) (LOWERED) .
- Refer to INSTALLING D-PILLAR TRIM PANEL ON LEFT AND RIGHT .
- Refer to INSTALLING COVER OF THE LUGGAGE COMPARTMENT SIDE SHELF LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING THE GRAB HANDLE AT THE REAR LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT B-PILLAR TRIM PANEL PARTIALLY .
- Refer to INSTALLING INTERIOR ROOF LIGHT .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING THE SUN VISORS AND COUNTER SUPPORT ON THE LEFT AND RIGHT .
- Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .
- Refer to INSTALLING GLASS SLIDE/TILT SUNROOF PANEL .
- Refer to ADJUSTING GLASS SLIDE/TILT SUNROOF PANEL .
- Refer to INSTALLING THE BELLOWS FOR THE GLASS SLIDE/TILT SUNROOF .
- Refer to INITIALIZING THE GLASS SLIDE/TILT SUNROOF .