Installing the trim on the front bumper cover

Check 

• Check the detents (1) on the bumper cover for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» Detents (1) are damaged.

Measure 

• Replace the bumper cover.
• Position the trim (1) and clip it into the detents (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FOG LIGHT BRACKET ON THE LEFT AND RIGHT .
• Refer to PARTIALLY INSTALLING THE BUMPER BRACKET ON THE LEFT AND RIGHT .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
• Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
• Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
• Refer to INSTALLING THE FRONT HOOD SEAL .