Adjust lock striker

Precondition

The screws on lock striker are loosened so far that the lock striker can still be shifted.

NOTE: TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: GAP DIMENSIONS FOR BODY .

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust the height of the lock striker so that the door lock does not bump or drag.
Move lock striker sideways in order to adjust the gap dimensions between door and rear quarter panel.

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATION

Lock striker
screw	Tightening torque	21 Nm