Installing the LED module for the turn signal lamps

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Check the seal (1) on the LED module (2) for damage and replace as needed.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect the connector (1) to the LED module (2) and lock it.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the LED module (2) on the headlamp.

Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATION

LED turn signal on headlight
Screw	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.