Installing the rotor position sensor
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multipin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: 61 35... NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .
- Hold the rotor position sensor (4) against the component housing with one hand and counter support it at the connector (2) with the other hand.
Do not touch the ribbon cable (3).
Do not kink ribbon cable (3).
Do not apply a tensile load to the ribbon cable (3).
- Take the rotor position sensor (4) out of the packaging and install it.
- Join upper section of connector (1) to lower section of connector (2).
- Turn screws (1) until hand-tight.
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATION
| Rotor position sensor to bearing cap | |
|---|---|
| M5 Replace screws. |
4.5 Nm |
- Tighten the screws (3).
TIGHTENING TORQUE SPECIFICATION
| Lower section of connector to upper section of connector (rotor position sensor) | |
|---|---|
| 2 Nm | |
- Close the holder (2).