Installing the crankshaft sensor
- Guide in and install crankshaft sensor (2) and install.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATION
| Crankshaft sensor to crankcase | ||
|---|---|---|
| TS5x20 | tightening torque | 6 Nm |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- With automatic transmission:
Insert and install the holder (2).
Make sure that the holder (2) is installed correctly in the guide (3).
Position the transmission oil line 4 on the bracket 2.
Secure clamps (1).
- With automatic transmission:
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATION
| Holder on end cover | ||
|---|---|---|
| M6X16 | Tightening torque | 8 Nm |
- Insert and position the holders (2).
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATION
| Holder for transmission oil line | ||
|---|---|---|
| Screw | Tightening torque | 4 Nm |
Follow-up work
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .