Installing the crankshaft sensor

Feed in and install the crankshaft sensor (3).
Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATION

Crankshaft sensor to crankcase
Crankshaft sensor	tightening torque	4.5 Nm

G14192357

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.
The connector (1) must engage audibly.
With automatic transmission:
Insert and install the holder (2).

Make sure that the holder (2) is installed correctly in the guide (3).

Position transmission oil line (4) on holder (2).

Secure clamps (1).

Courtesy of BMW OF NORTH AMERICA, INC.
With automatic transmission:
Tighten down screw (3).

TIGHTENING TORQUE SPECIFICATION

Holder on end cover
M6X16	Tightening torque	8 Nm

G14192355

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and position the holders (2).
Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATION

Holder for transmission oil line
Screw	Tightening torque	4 Nm

Guide in and position manifold support (2).
Hand-tighten the bolts (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATION

Manifold bracket on intake plenum
M6x25	tightening torque	8 Nm

G14191085

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screws (1) at the manifold brackets (2).

TIGHTENING TORQUE SPECIFICATION

Manifold bracket to crankcase
M6x16	tightening torque	8 Nm

G14191086

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
Refer to INSTALLING ACOUSTIC COVER .