Install the headlining with sliding/tilting sunroof (on the left or right, lowered)

Precondition 

The front seats have been fully adjusted towards the bottom.

The front seat backrests have been fully adjusted towards the rear.

The rear seat backrest is folded down toward the front.

• Check the clips (1) on the headlining for damage and, if necessary, replace them.
• Check the clamps (2) along the dashed line for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the headlining (1) with the help of an auxiliary person onto the respective edge protection.
• Clip in headlining (1) on the clips (2).
• Clip the headlining (1) in the area of the dotted line at the slide/tilt sunroof unit and the clamps (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the screw (1) on the headlining (2).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Headlining on frame
  Oval-head screw	tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING D-PILLAR TRIM PANEL .
• Refer to INSTALLING THE COVER OF THE LUGGAGE COMPARTMENT .
• Refer to INSTALLING C-PILLAR TRIM PANEL .
• Refer to INSTALLING THE GRAB HANDLE .
• Refer to INSTALLING B-PILLAR TRIM PANEL .
• Refer to INSTALLING INTERIOR ROOF LIGHT .
• Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
• Refer to INSTALLING THE SUN VISOR AND THE COUNTER SUPPORT .
• Refer to INSTALLING A-PILLAR TRIM PANEL .