Installing the guide for the rear center bumper cover
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Position the guide for the rear center bumper cover.
- Tighten nuts (1).TIGHTENING TORQUE SPECIFICATION
Bumper guide to body Hexagon nut Tightening torque 4.6 Nm - Clip in wiring harness (1) with holders (2).
- If necessary, connect and lock the connectors.
Follow-up work
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .