Install rear power electric windows

• Install the power electric windows and connect the connector (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed power windows (2) into the side section.

  Correctly feed the lower screw into the bracket.

• Apply the screws (1) until the power electric windows can still be shifted.

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting the rear window shaft dimension 

• Adjust the window cavity dimension (A) and (B) by shifting the power electric windows.
• Measure the window cavity dimension (A) and (B) between the angle bracket and the inner edge of the side section.

  Dimension A (front)	Dimension B (rear)
  32.8 mm	32.8 mm

• Tighten screws (1) on the rear power electric windows.

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATION
  
  

  Rear power window (angle bracket above)
  Oval-head screw	Tightening torque	9.5 Nm

• Install sound insulation (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (2).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Rear power window (screw below)
  Hexagon screw	Tightening torque	12 Nm

• Fold down the cover (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to ATTACHING THE REAR INNER WINDOW CHANNEL STRIP .
• Refer to INSTALLING REAR TRIM PANEL .
• Refer to INSTALLING THE UPPER TRIM PANEL ON ROLLOVER PROTECTION SYSTEM .
• Refer to INSTALLING THE REAR LEFT AND RIGHT HEAD RESTRAINT GUIDES .
• Refer to INSTALLING REAR LEFT AND RIGHT HEAD RESTRAINTS .
• Refer to REMOVING REAR SEAT BACKREST .
• Refer to INSTALLING THE LEFT AND RIGHT BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR SEAT .
• Refer to INSTALLING THE INNER DOOR SILL COVER STRIP .
• Refer to ATTACHING THE REAR OUTER WINDOW RECESS FINISHER STRIP .