Install the transmission bearing support
- Install transmission bearing support holder (3).
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATION
| Transmission bearing support to body | ||
| M8 | Tightening torque | 19 Nm |
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATION
| Rubber mount to transmission bearing support | ||
| M8 | Tightening torque | 19 Nm |
- Install the retaining plate (2).
- Tighten nuts (1).
TIGHTENING TORQUE SPECIFICATION
| Retaining plates for vehicle underbody cover | ||
| Sheet metal nut/plastic nut Replace nuts. |
tightening torque | 3 Nm |
Follow-up work
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .