Installing the lid for the rear differential (M Sport differential)
- When positioning the lid, ensure that pin (1) is aligned in gap (2).
- Position the lid (2).
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Lid to rear axle differential | ||
| M12 | tightening torque | 140 Nm |
| M10 | tightening torque | 90 Nm |
Follow-up work
- Refer to INSTALLING THE SERVOMOTOR .
- Refer to RAISING REAR DIFFERENTIAL AND SECURING (WITH GHAS) .
- Refer to CHECK/TOPPING UP OIL LEVEL IN THE REAR DIFFERENTIAL .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .