Remove complete exhaust system
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Component with heavy weight.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
Remove the connecting support from the tunnel
- Remove screws (arrows).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Loosen clamp (1).
- Loosen screws (2).
- Feed out and remove the connecting support (3) on the tunnel.
- Version 1 (Ribbon clamp)
Detach the ribbon clamp (1).
- Version 2 (V-band clamp)
Unfasten circlip (1).
- Loosen nut (1).
- Release the nut (1) on the rear axle support.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Unlock plug connection (1) and disconnect.
- Loosen nuts (2).
- Lower and remove the exhaust system (3) with the assistance of a second person.