Attaching the camber control arm and trailing arm to the wheel carrier

• Replace the nuts (1) and (2) and the screws (3) and (4).

  Parts:  Nut and screws

• Position the camber control arm and trailing arm on the wheel carrier.
• Insert screws (3) and (4).
• Tighten nut (1).

TIGHTENING TORQUE SPECIFICATION

Camber control arm to wheel carrier
M14 Replace screw and nut.	Joining torque	165 Nm
	Angle of rotation	90°

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION 
Tighten the screw connection in the NORMAL POSITION .

• Tighten the nut (2) hand-tight.

  The screw connection is tightened later in NORMAL POSITION .