Install the rear headlining partially

• Check the clips (2) on the headlining for damage, replace if necessary.
• Position the headlining (1) and feed it into the respective edge protection.
• Clip in the headlining (1) with the clips (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The operations shown only for one side must be carried out on both sides.
• Fasten the screw (1) on the headlining (2).

TIGHTENING TORQUE SPECIFICATION

Headlining on frame
Oval-head screw	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.