Connect the coolant lines for the low-temperature coolant circuit
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.
Make sure that the connections are locked correctly. The locks must engage audibly.
- Check the sealing rings (1) of the coolant lines (2) for damage and replace if necessary.
- Connect and lock the coolant line (1).
Coolant line (1) must engage audibly.
- Insert and install the cover (2) at the bottom left front.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATION
| Lower side cover at front | ||
|---|---|---|
| Hexagon screw for thermoplastic | Tightening torque | 3 Nm |
Follow-up work
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .