Installing starter motor
- Make sure that the acoustic cover (1) is not damaged.
- Carefully push the acoustic cover (1) aside.
- Insert and install the starter (3) in the direction of the arrow.
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATION
| Starter motor to engine | ||
|---|---|---|
| M8X60 | tightening torque | 19 Nm |
- Position the acoustic cover (2).
- Fasten expanding rivet (1).
- Secure the clamps (arrows).
- Fasten the christmas tree clip (2).
- Fasten expanding rivet (1).
- Secure clamps (arrow).
- Fasten the positive battery cable (3) in the holder (4) and position on starter.
- Tighten the nut (2) hand-tight.
- Connect connectors (1) and lock audibly.
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Correctly attach the positive battery cable (1) to the anti-twist lock (2).
- Tighten nut (3).
TIGHTENING TORQUE SPECIFICATION
| Battery positive lead to starter | ||
|---|---|---|
| M8 | Tightening torque | 13.5 Nm |
Follow-up work
- Refer to IF INSTALLED: INSTALLING UNDERBODY PROTECTION FOR THE STEERING .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .