Installing the rear power window switch

• Feed the power window switch (3) into the door trim panel (2) and clip into the detent (4).
• Attach the power window switch (3) using repair screws (1).
• Tighten the repair screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Power window switch on door trim panel
  Screw	Tightening torque	2 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  CONSUMABLE SPECIFICATION
  
  

  Repair screw  Delta PT4

  ø4 mm, l = 12 mm,

  07149200941

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE LED MODULE FOR THE REAR DOOR POCKET .
• Refer to INSTALLING SOUND INSULATION AT THE REAR DOOR TRIM PANEL .