Installing the support for the bumper cover
NOTE:
The operations shown only for one side must be carried out on both sides.
- Feed in the support for the bumper cover (3)
from the front.
If necessary, connect any present connectors.
- Replace screws (2)
.
Parts: Screws
- Position the screws (2) and hand-tighten them.
- Position the screws (1)
and hand-tighten them.
- Position the support (1)
so that the bore (3)
is in the center to the recess (4)
.
The surfaces (2) must be parallel to each other while doing so.
- Position the support (1)
so that the surfaces (2)
are parallel to each other.
- Tighten the screws (2)
.TIGHTENING TORQUE SPECIFICATION
Front bumper bracket to engine mount Hexagon screw with flange
Replace screwTightening torque 100 Nm Angle of rotation 180° - Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATION
Vertical connection to deformation element Hexagon screw Tightening torque 21 Nm
NOTE:
TECHNICAL INFORMATION
The setpoint torque deviates from the adjustable torque when using special tool 2 464 950.
The setpoint torque deviates from the adjustable torque when using special tool 2 464 950.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Convert setpoint torque into adjustable torque:
(setpoint torque * L1)/L2 = adjustable torque
L1 = length from the center of the grip to the reversible ratchet head
L2 = length from the center of the grip to the center point of the ring on the special tool
- Tighten the screw (1)
with the special tool 2 464 950
and the torque wrench.
The special tool and torque wrench must be aligned with tightening the screw.
TIGHTENING TORQUE SPECIFICATIONVertical connection to deformation element Hexagon screw Setpoint torque 21 Nm
Follow-up work
- Refer to INSTALLING SUPPORT FOR BUMPER COVER AT FRONT BOTTOM .
- Refer to FASTENING THE AIR DUCT FOR THE COOLANT RADIATOR TO THE SUPPORT FOR THE BUMPER COVER .
- Refer to INSTALLING INTAKE PORT .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE RIGHT FRONT-END STRUT .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to INSTALLING THE LEFT AND RIGHT FANFARE HORN .
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to IF INSTALLED: INSTALLING THE FRONT RADAR SENSOR (FRS) WITH THE BRACKET .
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to REPLACING UPPER ADAPTER FOR BUMPER TRIM PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING COVERS AT FRONT BOTTOM ON LEFT AN RIGHT SIDES .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to ADJUSTING HEADLIGHTS .