Remove the bellows of the central mount

Preliminary work 

• Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
• Refer to REMOVING COMPLETE EXHAUST SYSTEM .
• Refer to REMOVING THE HEAT SHIELDS .
• Refer to COMPLETELY REMOVING THE PROP SHAFT (PLUG-IN - REAR FLEXIBLE DISC) .

• Detach the bellows (1) from the groove (2).
• Identify the installation position of the prop shaft (3) and the rear prop shaft (4) in a plane.

  The identification makes it possible for the front and rear prop shaft to be installed in the same position.

  This ensures that the prop shaft is balanced again in the section after installation.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Pull the prop shaft apart in the direction of the arrow.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release the bellows (1) out of the groove (2) using a screwdriver and detach via the longitudinal splines.

  Courtesy of BMW OF NORTH AMERICA, INC.