Remove right output shaft
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00... RAISING THE VEHICLE WITH A VEHICLE LIFT .
Preliminary work
- Refer to REMOVING FRONT RIGHT WHEEL .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THRUST FIELD .
- Refer to REMOVING THE COVER FOR THE STEERING ASSEMBLY .
NOTE:
Description is for left component only. Procedure on the right side is identical.
NOTE:
Counter-hold at the Torx socket.
- Detach the anti-roll bar link (2) from the spring strut.
- Turn swivel bearing outward.
- Set aside the anti-roll bar link (2).
- Guide out the output shaft (1) from the swivel bearing.
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Position the aluminum drift (2) on the output shaft (1).
- Knock output shaft (1) with the aluminum drift (2) out of the bearing support.
- Remove the output shaft (1) in the direction of the arrow.