Installing the front brake hose (high brake)
- Fit and tighten brake hose (1) on brake caliper.
If necessary, grip at knurling (2).
TIGHTENING TORQUE SPECIFICATION
| Brake hose to brake caliper, front | ||
| tightening torque | 17 Nm | |
- Make sure the brake hose is not twisted and resting on components attached to the body.
- Hook the brake hose into holder (3).
- Attach and tighten union screw (1).
Hold on to square shaft, if necessary (2).
TIGHTENING TORQUE SPECIFICATION
| Brake pipe screw connection/Union screws | ||
| tightening torque | 17 Nm | |
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .