Removing the center cowl upper part
Preliminary work
- Refer to REMOVING THE SEAL FOR THE HOOD REAR .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING LEFT AND RIGHT WIPER ARM .
- Refer to REMOVING WINDSHIELD PANEL COVER .
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Loosen screws (1) and (2).
- Remove tension strut (3) at the shock tower upwards.
- Version with mild hybrid technology:
Unclip wire (1) from the holders (arrows).
- Unscrew the bolts in the marked areas.
- Remove the center cowl upper part (1).