Install the seat belt finisher strip

Check 

• Check the clamps (1) on the seat belt finisher strip for damage; if necessary, replace them.
• Check the detent (2) on the seat belt finisher strip for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» Detent (2) is damaged

Measure 

• Replace the seat belt finisher strip.
• Feed the safety belt through the seat belt finisher strip.
• Clip in the seat belt finisher strip with the detent (3) and clamps (2).
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Seat belt finisher strip to angle bracket
  Sheet metal screw 4.8x19 Replace screw.	Tightening torque	2.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE STRAP FITTING AT THE REAR .
• Refer to INSTALLING THE REAR SEAT .
• Refer to INSTALLING D-PILLAR TRIM PANEL .
• Refer to INSTALLING C-PILLAR TRIM PANEL .
• Refer to INSTALLING THE COVER OF THE LUGGAGE COMPARTMENT .
• Refer to INSTALLING THE FRONT STORAGE SHELF .