Install the sensor line for the contactless trunk opening (top)
- Clip in top sensor line (3) from above.
- Fasten the cable at the clips (2).
- Connect plug (1).
- Position brace for the rear bumper (2) on the support.
- Install the expanding rivet (1).
- Clip in the cable clips (2) on the inside of the brace for the rear bumper (3).
- Tighten the screws (1).
tightening torque specification
| Rear bumper cover mount to support for rear bumper | ||
|---|---|---|
| Hexagon screw for thermoplastic | Tightening torque | 2.6 nm |
Follow-up work
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL LEFT AND RIGHT PARTIALLY .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .