Installing the backrest covering

• Carefully feed the backrest covering (1) into the marked area (3) on the cushion (2) from above.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure all trim wires (1) with clamps.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the clamps (2).

  Parts:  Clamps

• Insert the clamp (2) with the special tool  0 492 668 (52 0 050)  .
• Clasp the trim wire (3) of the cushion (1) and the trim wire (4) of the backrest covering (5) with the clamp (2) and bend the clamp (2) shut.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE BACKREST COVERING WITH THE CUSHION FOR THE REAR SEAT .
• Refer to INSTALLING THE REAR SEAT BACKREST .
• Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR SEAT .