Install the roof-mounted antenna
- Locks (1) on the roof-mounted antenna (2) must be correctly fitted under the roof (3).
- Install the roof-mounted antenna (2) in the direction of the arrow.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATION
| Roof-mounted aerial to roof outer skin | ||
|---|---|---|
| screw | Tightening torque | 4 Nm |
- Correctly position TCB (1) and push in arrow direction till the lock is engaged (2).
Follow-up work
- Refer to INSTALLING THE ROOF-MOUNTED ANTENNA HOUSING .
- Refer to PARTIALLY INSTALLING THE REAR (LOWERED) HEADLINING (WITH SLIDING/TILTING SUNROOF) .
- Refer to PARTIALLY INSTALLING THE REAR HEADLINING (LOWERED) .
- Refer to INSTALLING THE LEFT AND RIGHT B-PILLAR TRIM PANEL .
- Refer to PARTIALLY INSTALLING THE REAR LEFT AND RIGHT SIDE TRIM PANEL .
- Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING INTERIOR ROOF LIGHT .
- Refer to INSTALLING THE TRIM OF THE 3RD BRAKE LIGHT .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .