Remounting (basic) the control unit for the Front Light Electronics (FLE)

Removing the control unit for the Front Light Electronics (FLEL) (LED basic)

Loosen screws (1).
Feed out the control unit for the Front Light Electronics (FLEL) (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock plug connection (1) and disconnect.
Remove the control unit for the Front Light Electronics (FLEL) (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the Front Light Electronics (FLEL) control unit (LED basis)

Check seal (3) for damage and replace if necessary.
Position the Front Light Electronics (FLEL) control unit (2).
Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in the Front Light Electronics (FLEL) control unit (2) and correctly position.
Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

Front Light Electronics control unit on headlight
Screw	tightening torque	1.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.