Installing seat belt extender hand
NOTE:
TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Thread the shoulder belt (3) into the seat belt extender hand (1).
- Carefully feed the seat belt extender hand (1) into the seat belt extender (2) in the arrow direction.
Follow-up work
- Refer to INSTALLING THE FRONT STRAP FITTING .