Removing seat-belt assistant hand
NOTE:
TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Preliminary work
- Refer to REMOVING THE FRONT STRAP FITTING .
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Feed out the seat-belt assistant hand (1) in direction of arrow from the seat belt extender (2) carefully.
- Feed out upper seat belt (3) from the seat-belt assistant hand (1).