Install tension strut on shock tower

• Install tension strut (3).
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Tension strut on bulkhead
  M10x35 screw Replace screws.	Tightening torque  Angle of rotation	56 Nm 90°

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (2).

  Parts:  Screws

• Tighten down screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Tension strut to shock tower
  M10x70 screw Replace screws.	Tightening torque  Angle of rotation	56 Nm 90°

Follow-up work 

• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALLING THE REAR HOOD SEAL .