Removing the eccentric shaft (cylinder head removed)
NOTE:
RISK OF DAMAGE
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .
Contaminant or foreign body .
Contamination can result in malfunctions, loss of function or leaks .
- Adhere to the utmost cleanliness.
- Protect components from contamination e.g. by covering.
- Close off line connections with seal plugs.
- Remove all screws (marks).
- Guide out and remove bearing brackets (1) to (6) (arrows).
- Set down bearing brackets (1) to (6) neatly in special tool 0 495 105 (11 4 480) .
- Feed out and remove bearing cap (A) .
- Place bearing cap (A) neatly in special tool 0 495 105 (11 4 480) .
- Feed the air eccentric shaft (1)
out toward the top and remove.