Remounting when replacing the dashboard trim panel

Preliminary work 

• Refer to ADJUSTING THE STEERING COLUMN POSITION .
• Refer to REMOVING CUP HOLDER .
• Refer to REMOVING THE CENTER ARMREST STORAGE COMPARTMENT TRIM .
• Refer to REMOVING THE CENTER CONSOLE TRIM .
• Refer to REMOVING THE DECORATIVE TRIM ON THE CENTER CONSOLE ON THE LEFT AND RIGHT .
• Refer to REMOVING THE WIRELESS CHARGING STORAGE .
• Refer to REMOVING THE OPERATING FACILITY IN THE CENTER CONSOLE .
• Refer to REMOVING THE STORAGE COMPARTMENT IN THE FRONT CENTER CONSOLE .
• Refer to REMOVING THE REAR CENTER CONSOLE TRIM .
• Refer to REMOVING THE CENTER CONSOLE .
• Refer to REMOVING THE SIDE PANEL ON THE LEFT DASHBOARD .
• Refer to REMOVING THE SIDE PANEL ON THE RIGHT DASHBOARD .
• Refer to REMOVE A-PILLAR TRIM PANEL, LEFT AND RIGHT .
• Refer to REMOVING LIGHT OPERATING UNIT .
• Refer to REMOVING THE TRIM PANEL FOR PEDAL MECHANISM .
• Refer to REMOVING LEFT FOLD-OUT COMPARTMENT .
• Refer to REMOVE THE DECORATIVE STRIP ON THE DASHBOARD ON THE LEFT .
• Refer to REMOVE RIGHT FOOTWELL TRIM .
• Refer to REMOVE THE DECORATIVE STRIP ON THE RIGHT DASHBOARD .
• Refer to REMOVING CENTRAL INFORMATION DISPLAY (CID) .
• Refer to REMOVING AIRBAG UNIT .
• Refer to REMOVING AIRBAG UNIT (M SPORT STEERING WHEEL) .
• Refer to REMOVING THE SPORTS STEERING WHEEL .
• Refer to REMOVING THE STEERING WHEEL/M SPORT STEERING WHEEL .
• Refer to REMOVING STEERING COLUMN SHROUD UPPER SECTION .
• Refer to REMOVING STEERING COLUMN SHROUD LOWER SECTION .
• Refer to REMOVING THE STEERING COLUMN SWITCH CLUSTER (SZL) .
• Refer to REMOVING THE INSTRUMENT CLUSTER (KOMBI) .
• Refer to REMOVING THE AUDIO CONTROL UNIT .
• Refer to REMOVING THE SPEAKER TRIM AT THE DASHBOARD .
• Refer to REMOVING THE SPEAKER HOLDER ON THE DASHBOARD .
• Refer to REMOVING THE TRIM PANEL FOR THE DASHBOARD .

Removing the glove compartment damper 

• Release the plug connection (1)  from the dashboard and pull outward.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release damper (1)  from angle bracket (2)  (slightly splay in direction of arrow).
• Open glove compartment lid.
• Turn damper (1)  slightly in clockwise direction and remove outward.
• Guide the damper (1)  out of the instrument panel.
• Disconnect plug connection (3)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Remove glove box lid 

Prerequisite 

The glove box lid is open.

• Slightly raise the glove box lid (1)  .
• Carefully bend the side sections (2)  of the glove box lid (1)  inwards so that the glove box lid (1)  can be fed out of the dashboard.
• Swivel the glove box lid (1)  downwards until it is fed out at the hinges.

Courtesy of BMW OF NORTH AMERICA, INC.

Install glovebox cover 

Prerequisite 

The glove box lid is open.

• Feed in the glove box lid (1)  on the hinges and swivel upwards.
• Carefully bend the side sections (2)  of the glove box lid inwards (1)  and feed into the instrument panel.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the glove compartment dampers 

• Connect plug (3)  .
• Feed the damper (1)  into the dashboard.
• Open glove compartment lid.
• Install the damper (1)  and slightly twist in counterclockwise direction.
• Engage the damper (1)  at the angle bracket (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the plug (1)  and fasten it to the dashboard.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove glove box light 

• Lift out glove box light (1)  at marked position (arrow).
• Disconnect associated plug connection.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the glove box light 

• Connect associated connector.
• Install the glove box light (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Removing the air ducts in the dashboard 

• Disengage left air duct (1)  at the detents (arrows).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Disengage right air duct (1)  at the detents (arrows).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Disengage air ducts (1)  at the detents (arrows).
• Disengage air ducts (1)  upwards out of the detents (2)  .
• Feed out air ducts (1)  and remove from dashboard.

Courtesy of BMW OF NORTH AMERICA, INC.

Removing front passenger airbag 

• Unlock plug connection (1)  and disconnect.
• Unclip the cable clip (2)  .
• Loosen screw (3)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock the front passenger airbag (1)  in arrow direction and remove upwards.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the front passenger airbag 

• Correctly position the front passenger airbag (1)  and lock in arrow direction.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (3)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Front passenger airbag on dashboard trim
  Oval-head screw	Tightening torque	2 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the cable bracket (2)  .
• Connect plug connection (1)  and lock.

Installing the air ducts in the dashboard 

• Guide the air ducts (1)  into the dashboard and position.
• Engage the air duct (1)  on the detents (2)  from the top.
• Engage the air ducts (1)  into the latch mechanisms (arrows).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Engage the right air duct (2)  on the detents (arrows).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Engage the left air duct (1)  on the detents (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the wiring harness (1)  and remount on the new dashboard trim.

Courtesy of BMW OF NORTH AMERICA, INC.