Installing the trim on the rear bumper cover

Check 

• Check detents (arrows) for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» The detents are damaged.

Measure 

• Replace the trim on the rear bumper cover.

• Position trim (2)  on the rear bumper cover (1)  and insert it into guides (3)  on the left and right.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip trim (2)  into all detents (3)  of the rear bumper cover (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
• Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL LEFT AND RIGHT PARTIALLY .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WELL IN FRONT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to IF INSTALLED: INSTALLING THE EMERGENCY WHEEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .