Remove the rear top cross connection
Preliminary work
- Refer to REMOVING SEAL FOR FRONT HOOD .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REPLACEMENT: REBUILD THE HOLDER .
- Refer to IF INSTALLED: PARTIALLY REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Release the clips (arrows) in the marked areas from the cross connection (1)
at the rear top.
- Loosen screws (1) .
- Loosen screws (2) .
- Feed out and remove cross connection (3) at rear top.