Installing the speaker cover on the front door trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Saw off all welding pins (1) along the molding (2) .
Refit speaker cover
Speaker cover (installation)
- With a support person, pull the door pocket (1) and cover (2) away from the support until the speaker cover (3) can be fed in.
- Very carefully feed in and install the speaker cover (3)
on the cover (2)
and the door pocket (1)
.
The speaker cover must be fed in very carefully to avoid damaging the door pocket.
- Remove the adhesive tape in area (3) .
- Remove the adhesive tape (1)
from the door pocket and in the entire area of the speaker cover (2)
.
- Correctly put the upper section of the door pocket (1)
back in the area of the speaker cover (2)
.
- Engage the detents (1) by applying pressure on the speaker cover from the top.
The detents (1) must lock correctly.
Installing the repair screws
Spot-welds or attachment points
Arrow Spot-welds (removal) or attachment points (installation)
- Insert and tighten the repair screws at the attachment points (arrows).
TIGHTENING TORQUE SPECIFICATION
| Repair screw to door trim panel | ||
| Oval-head screw M4x10 |
Tightening torque | 2.0 Nm |
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATION
| Speaker cover on door trim panel | ||
| Screw | Tightening torque | 2.3 Nm |