Remove brake booster

Preliminary work 

• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to IF INSTALLED: REMOVING STRUT BRACE IN THE REAR OF THE ENGINE COMPARTMENT .
• Refer to REMOVING THE EXPANSION TANK (VEHICLES WITH MANUAL TRANSMISSION) .
• Refer to REMOVING THE TANDEM BRAKE MASTER CYLINDER .
• Refer to REMOVING THE TRIM PANEL FOR PEDAL MECHANISM .

• Remove air duct (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove check valve (1)  from brake booster in the arrow direction.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Retract release tool 2 409 646  between brake pedal and brake booster.
• Apply support (1)  of the release tool 2 409 646  on the bearing bracket. If necessary, position the support by rotating the screw on the release tool.

Courtesy of BMW OF NORTH AMERICA, INC.

• Press the release tool 2 409 646  in arrow direction and lever out brake pedal from the brake booster.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen nuts (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unscrew the brake booster (1)  from the bulkhead.

Courtesy of BMW OF NORTH AMERICA, INC.