Installing front brake caliper (high brake)

• Install the brake caliper in the arrow direction.
• Replace screws (1)  .

  Parts:  Screws

• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Fit and tighten brake hose (1)  on brake caliper.

  If necessary, grip at knurling (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the brake hose is not twisted and resting on components attached to the body.
• If necessary, hook the brake hose in the holder (3)  .

Follow-up work 

• Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE (BRAKE HIGH) .
• Refer to INSTALL FRONT PADS (HIGH BRAKE) .
• Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
• Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR (HIGH BRAKE) .
• Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND BLEED THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to COMMISSIONING OR BEDDING IN (BRAKE) OF NEW BRAKE PADS AND DISCS (HIGH BRAKE) .