Partially installing the bumper bracket on the left and right
NOTE:
Description is for left component only. Procedure on the right side is identical.
Partially installing the bumper bracket
- Feed in the bumper bracket (2) from below and clip in with detents (3) .
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATION
| Bumper bracket, side front | ||
|---|---|---|
| screw | Tightening torque | 3 Nm |
Follow-up work
- Refer to INSTALL BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALL CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .