Installing the anti-roll bar
- Feed in the anti-roll bar (2) and position on the front subframe
- Replace screws (1)
Parts: Screws
- Tighten down screws (1)
TIGHTENING TORQUE SPECIFICATION
| Retaining bracket, anti-roll bar, to front axle support | ||
|---|---|---|
| M8 Replace screw |
Tightening torque | 28 Nm |
Follow-up work
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .